How to bind X4RSB reciever for PPM?

0 votes
asked Feb 8, 2016 in Building by cmengler (2,270 points)
retagged Feb 8, 2016 by cmengler

I have flashed my X4RSB receiver with the "X4R-X4RSB-CPPM- Non-EU Version" firmware from here. What is the steps to bind this to my Taranis to use PPM?

1 Answer

0 votes
answered Feb 8, 2016 by cmengler (2,270 points)
  1. Place a jumper over signal pins 2 and 3 on the RX.
  2. Press and hold the F/S (failsafe) button on the RX.
  3. Connect power (+/-) on pin 1 to power up the RX, typically from a 5V BEC.
  4. Release the F/S button on the RX.
  5. On the Taranis, select mode D16 and channel range CH1-8.
  6. Ensure the Taranis is ~1 metre away from the RX, select the [Bind] function.
  7. The Taranis will beep (~1 second) and the RX will begin blinking red to indicate a successful bind.
  8. Power off the RX.
  9. Remove the jumpers, they are only required for the binding process.